BMW 2 Series F45 / F46 Active / Gran Tourer 3D-printable parts
Free STL files for replacement parts, clips, brackets and accessories that fit the 2 Series F45 / F46 Active / Gran Tourer (2014–2021). Print at home in PLA, PETG, ABS or Nylon.
Rear-Vent Airflow-Linkage Repair
Replacement linkage between the rear center-console vent thumbwheel and airflow flap on BMW F45/F46 Active Tourer and Gran Tourer, including pre-LCI and LCI. Remove the vent assembly for access, verify linkage orientation, and use a cabin-heat-resistant material.
Parcel-Shelf Retaining Hook
Replacement hook that retains the cargo cover in position on the BMW F45 2 Series Active Tourer. Creator photographs show the physical hook installed; compare mounting orientation and clearances before fitting.
Console-Storage Phone-Mount Base
Four support-free mounting-base variants that clip into the small center-console storage pocket of BMW F45/F46 models. Includes fixed and rotating plates; rotating versions use an M5 nut and 12–20 mm bolt. Use PETG, ASA, or ABS rather than ordinary PLA.
RHD Armrest-Compartment Organizer Tray
Organizer tray for the compartment beneath the armrest in right-hand-drive BMW F45 Active Tourer and F46 Gran Tourer models. The source photograph shows the printed tray installed; this fitment is RHD-specific.
Parcel-Shelf Rubber Buffer
Flexible replacement for BMW rubber buffer 51466967605, creator-tested on an i3 and catalogued for F45, E81/E87, F20/F21, I01, and X1 E84. Print in approximately 85A TPU and cut out the temporary support tab after printing. Within the combined E8x generation, documented fitment is E81/E87 only.
Energy-Drink Can Cup-Holder Adapter Ring
Short adapter ring that centers narrow energy-drink cans in the factory cup holder of BMW F45 Active Tourer and F46 Gran Tourer models. The creator physically tested the reduced-height ring and photographed it installed.