BMW X6 3D-printable parts

Replacement retaining hook for the roller sunshade in a rear door. The creator modeled it for the fourth-generation X5, shows the printed clip next to the original, and documents it installed and holding the shade. The printed hook is intentionally slightly shorter than the original. BMW component 51 35 7 479 511 is catalogued for the G05 X5 and G06 X6 rear-door shade application, so both evidence-backed generations are linked. Fitment requires the rear side-window roller sunblind equipment; confirm door trim, shade and mounting geometry by VIN. Print in a heat-resistant automotive material and test smooth release and secure retention before road use.

Replacement blanking plate for the center-armrest storage opening after removal of the factory telephone cradle. The creator modeled it for the second-generation X5, shows it physically fitted and states that the friction-fit print replaces BMW cover 51 16 9 115 083 without reproducing the original clips. BMW catalog evidence also lists that cover for the contemporary X6 E71/E72. Confirm the telephone/storage-console configuration and applicable option equipment by VIN, use a heat-resistant material, and verify that the plate remains secure without interfering with adjacent wiring or sockets.

Replacement upper hook bonded to the rear seat-back trim shell. The creator modeled it from a 3D scan of the original F16 component, physically compared the printed replacement with the original, and later corrected the upper section for proper attachment. Mirror the supplied file for the opposite side. Use a heat-resistant, tough cabin-suitable material, verify the hook orientation and seat-back shell geometry before bonding, and keep adhesive and the printed part clear of seat latches, belts, airbags and folding mechanisms.

Dash-cubby mount for the 10.26-inch Carpuride C94 display, physically fitted and tested by the creator in a 2013 X6. This submission includes only the source's tested 2 mm support version; the later 3 mm support variant was not test-fitted and is excluded. Use a heat-resistant cabin-suitable material, confirm the dashboard cubby geometry before printing, and route the display cable without obstructing vents, controls, airbags or driver visibility.

Frame and translucent diffuser for adding a slim legroom light along the upper rear seat-back panel. The creator identifies the design for the contemporary X5 and X6, supplies separate frame and diffuser files plus a combined-print alternative, states that both parts were printed in PETG, and shows the assembly physically installed. This is an electrical lighting retrofit rather than a verified replacement for a catalogued BMW component, so no OEM number is assigned. Confirm seat-back trim geometry, wiring, fuse protection, heat clearance and secure retention before use; never route wiring through seat airbag or adjustment paths.